OpenCart Templates
Home / Salt Water / DIY Bat Chummer…

DIY Bat Chummer…


One Wiffle-ball bat
One tube of silicone caulk


  1. Hold the bat securely and cut off the end at a steep angle with a hacksaw. For a straighter cut, draw the cut line with a ­pencil first.
  2. Fill the cavity of the bat handle with silicone caulk, and wait for it to harden before use. This prevents baits from getting trapped inside.

Note: Grip the bat with both hands (slightly apart) and mimic a casting motion to launch baits a greater distance with minimal effort. Position the longest part of the cut-off end away from the target area for best results.

Send us your original ideas, along with a sketch or photo. If we use your tip(s), we will send you a Shimano Baitrunner spinning reel, featuring a fast-retrieve, front-dial drag adjustment and popular baitrunner system, valued at up to $189.99! Submit to Salt Water Sportsman, Rigger’s Notebook, 460 N. Orlando Ave., Suite 200, Winter Park, FL 32789, or send via email to

Source link

About admin

Check Also

Lefty Kreh, 1925-2018…

There was only one Lefty. So pervasive was his imprint and influence on modern angling ...

Leave a Reply

Your email address will not be published. Required fields are marked *