Home / Reports / Circling Back on Tube and Worm Rigs…

Circling Back on Tube and Worm Rigs…

Green water broke over the foredeck, washed into the canted, tight vee of the high mahogany Cutty shield on the sea-kindly bass boat, then poured off either side, back to where it came from. Conditions were sloppy or, as my mate Andy would say, hairy along the edge of the rip line with the wind whipping up against the tide. The wave broke under our midsection, shoving us down the cresting surge as I racked the tiller to port to dig the keel into the backside and complete my pass along the steep drop-off. I wove in and out between the turbulence, dragging the baited tube and worm rig behind us until I read the peak of the second hump on the recorder and jogged to port, causing the weighted tubes to plunge toward the bottom of the slope.

“Got one,” came a call from the stern, where my deckmate was braced against the aft corner of the starboard gunwale, rod bent, and the fifth color of lead line slipping smoothly off the Penn Senator I’d preset with a fairly stiff drag. The heavy fish turned its broad body sideways in the strong current and dug for the bottom. Andy sensed the fish moving sideways across our stern toward his rod in the opposite rod holder, so I grabbed it and begin cranking for all I was worth to avoid a tangle.


Source link

About admin

Check Also

Angling Artists: Andrea Larko…

Andrea Larko creates bumper stickers, embroidered patches and hats, Abel fly reels, limited edition prints, ...

Leave a Reply

Your email address will not be published. Required fields are marked *